Back to Blog
Wireshark mac address filter7/9/2023 ![]() ![]() Like the MAC address, The LLC logical link control protocol is also layer 2, but is upper sublayer of Data Link Layer and won't affect the ability to capture the traffic unless you specify llc as a filter and there isn't any llc traffic, then you would get the blank screen. This will open the panel where you can select the interface to do the capture on. Observe that the Packet List Pane is now filtered so that only traffic to (destination). To apply a capture filter in Wireshark, click the gear icon to launch a capture. (I'm assuming the traffic you are looking for is traveling to a destination on another switch, outside the network, or at least to your gateway).īy specifying the MAC address filter, eth.addr eq xx:xx:xx:xx:xx:xx you are filtering for all traffic to and from that associated MAC address. How do I filter specific IP address in Wireshark Type ip. ![]() If you are trying to trace MAC's on the switch you are also connected to, then you'll want to sniff from a port which is spanned/mirrored to the port which has inbound/outbound traffic of that switch, so that you will see all the traffic coming in and out of the switch. ![]() For instance, tshark -i 1 -R "eth.addr eq xx:xx:xx:xx:xx:xx or eth.addr eq xx:xx:xx:xx:xx:xx" You can use a list for your MAC's in one display filter, but not a range, unless you switch to IP's instead of MAC's. ![]() If you are using a display filter of eth.addr = xx:xx:xx:xx:xx:xx and you are not seeing any information being displayed/sniffed, then the traffic for that MAC address is not passing through the port you're sniffing on. ![]()
0 Comments
Read More
Leave a Reply. |